The Keysight N6705B is a 4-slot DC Power Analyzer Mainframe that integrates up to four advanced DC power supplies, a digital multimeter, an oscilloscope, an arbitrary waveform generator, and a data logger. Providing a total of up to 600 W of output power, it offers an efficient benchtop solution for sourcing and measuring DC voltage and current into a device under test without complex setups or custom programming.
Specifications
General
| Parameter | Value |
|---|---|
| Interfaces | GPIB, USB 2.0, LAN (10/100) |
Physical
| Parameter | Value |
|---|---|
| Power Supply | 100 - 240 VAC, 50/60/400 Hz, 1440 VA max |
| Operating Temperature | 0 to 55 °C |
| Rack Width | Full rack |
Mainframe System Capabilities
| Parameter | Value |
|---|---|
| Number of Module Slots | 4 |
| Total Output Power Capacity | 600 W |
| Module Compatibility | Keysight N6700 series DC power modules |
| Command Processing Time | ≤ 1 ms (from receipt of command to start of output change) |
Measurement & Digitizer Specifications
| Parameter | Value |
|---|---|
| Scope Digitizing Rate | Up to 200 kHz |
Data Logger Specifications
| Parameter | Value |
|---|---|
| Minimum Sampling Interval | 20 µs |
| Maximum Sampling Interval | 60 s |
Protection and Limit Functions
| Parameter | Value |
|---|---|
| Inhibit (INH) Input Latency | 5 µs (from receipt of inhibit to start of shutdown) |
| Coupled Output Fault Latency | < 10 µs (from receipt of fault to start of shutdown) |
Connectivity, Interfaces and Triggering
| Parameter | Value |
|---|---|
| LAN Interface Standard | 10/100 Base-T |
| LXI Device Class Compliance | Class C |
Physical and Environmental
| Parameter | Value |
|---|---|
| Rack Height | 4U |
| Storage Temperature Range | -30 °C to 70 °C |
Power Requirements
| Parameter | Value |
|---|---|
| AC Input Voltage | 100 VAC - 240 VAC (nominal), 86 VAC - 264 VAC (active range) |
| Maximum Power Consumption | 1440 VA |
Environmental
| Parameter | Value |
|---|---|
| Operating Altitude | Up to 2000 m |
| Pollution Degree | Pollution Degree 2 |
| Installation Category | Installation Category II |
Safety
| Parameter | Value |
|---|---|
| Maximum Isolation Voltage to Chassis | 240 VDC (all terminals) |
General Specifications
| Parameter | Value |
|---|---|
| Instrument Warm-up Time | 30 minutes |
Interfaces & Programming
| Parameter | Value |
|---|---|
| SCPI Version | 1999.0 |
| Front Panel USB Port Type | USB 2.0 Host (Type A) |
Physical Connections
| Parameter | Value |
|---|---|
| Front Panel Output Connectors | 4 sets of 4-wire binding posts (plus, minus, +sense, -sense) |
| Front Panel Ground Terminal | 1 chassis ground binding post |
Arbitrary Waveform Generator
| Parameter | Value |
|---|---|
| Arbitrary Waveform Generator Max Steps in List Mode | 512 |
Technology
DC Power Sourcing, Measurement, and Analysis
Applications
Benchtop R&D DC power testing, power consumption analysis, and component characterization