SpecAtlasHub

TPS2024

Tektronix*misc

The Tektronix TPS2024 is a 200 MHz, 4-channel digital storage oscilloscope featuring isolated channels and battery power, specifically designed for making safe floating and differential measurements in demanding environments.

Electrical TestingPower ElectronicsPower Measurement

Specifications

General

ParameterValue
InterfacesRS-232, Centronics Parallel, CompactFlash (Type I/II)
Display5.7 inch (145 mm) color active-matrix TFT LCD, 320 x 240 pixels
Warranty3 years (excluding probes and accessories)

Physical

ParameterValue
Power Supply90 V to 250 V AC (45 Hz to 66 Hz) or battery power (up to 2 rechargeable Li-ion batteries)
Operating Temperature0 °C to +50 °C
Dimensions (W×H×D)336 mm × 161 mm × 130 mm
Weight2.7

Vertical System

ParameterValue
Analog Bandwidth (-3 dB)200 MHz
Calculated Rise Time (10% to 90%)1.75 ns
Number of Input Channels4 (IsolatedChannel)
Input CouplingAC, DC, GND
Input Impedance1 MΩ ± 2% in parallel with 20 pF ± 3 pF
Input Sensitivity Range2 mV/div to 5 V/div
Vertical Resolution8-bit
Maximum Input Voltage300 VRMS CAT II (BNC signal to shell)
Maximum Float Voltage600 VRMS CAT II (BNC shell to earth ground)
DC Gain Accuracy±3%
Hardware Bandwidth Limits20 MHz
Vertical Scale Range2 mV/div to 5 V/div
Channel-to-Channel Isolation≥ 100:1 at 100 MHz (with equal vertical scale settings)
AC Coupling Low-Frequency Limit<10 Hz at -3 dB (using 1X probe)
Linear Dynamic Range±5 divisions from screen center

Horizontal System

ParameterValue
Timebase Range2.5 ns/div to 50 s/div
Timebase Accuracy±50 ppm

Acquisition System

ParameterValue
Maximum Real-Time Sample Rate2.0 GS/s (on all channels)
Maximum Record Length2.5k points per channel
Acquisition ModesSample, Peak Detect, Average, Single Sequence

Trigger System

ParameterValue
Trigger SourcesChannel 1, Channel 2, Channel 3, Channel 4, Line
Trigger ModesAuto, Normal, Single Sequence
Trigger TypesEdge, Pulse Width, Video
Trigger Holdoff Range500 ns to 10 s
Trigger Sensitivity (Edge, DC Coupled)1.0 div from DC to 10 MHz; 1.5 div from 10 MHz to 200 MHz
Video Trigger FormatsNTSC, PAL, SECAM

Waveform Measurements and Analysis

ParameterValue
Automatic Measurements11 (Period, Frequency, +Width, -Width, Rise Time, Fall Time, Max, Min, Peak-to-Peak, Mean, Cycle RMS)
Waveform Math OperatorsAddition, Subtraction, Multiplication, FFT
FFT Window TypesHanning, Flat Top, Rectangular

Power Specifications

ParameterValue
Power Consumption40 W maximum
Battery OperationUp to 8 hours with 2 batteries installed (hot-swappable)
Battery TypeTPSBAT rechargeable Lithium-Ion

Environmental and Compliance

ParameterValue
Storage Temperature Range-40 °C to +71 °C
Operating HumidityUp to 90% RH at or below +30 °C
Operating AltitudeUp to 3,000 m

Physical Characteristics

ParameterValue
Weight with One Battery3.2 kg
Weight with Two Batteries3.7 kg

Channel Isolation

ParameterValue
Number of Isolated Channels4

Performance

ParameterValue
Common Mode Rejection Ratio (CMRR)100:1 at 60 Hz, 20:1 at 50 MHz (with P2220 probe)

Storage

ParameterValue
Front-Panel Setup Storage10 setups
Waveform Storage (Internal)4 waveforms
Removable Storage TypeCompactFlash (Type I, up to 2 GB)

Probe Compensator

ParameterValue
Probe Compensator Output Voltage5.0 V into ≥1 MΩ load
Probe Compensator Output Frequency1 kHz

Software

ParameterValue
Optional Application SoftwareTPS2PWR1 Power Measurement and Analysis Software

Power

ParameterValue
Battery Run TimeUp to 4 hours per battery (up to 8 hours with two batteries)

Safety & Compliance

ParameterValue
Overvoltage CategoryCAT II 300 V (BNC inputs)
Pollution DegreePollution Degree 2

Technology

Digital Storage Oscilloscope

Applications

Power electronic design, industrial troubleshooting, and floating measurements